Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
Connecting the Cables
■ ■ ■ ■ ■
■
69
Connecting the Cables
When you are using the following EPSON projector, follow
the instructions below. If not, please see the User’s Guide
packed with your projector.
♦
Caution:
Before connecting the cables to your computer, make
sure that the computer and projector are turned off and
unplugged from any power source; otherwise damage may occur.
Connecting to your PC
Using the PS/2 mouse
connect to the
PS/2 mouse port
connect to the
serial port
PC serial cable
PS/2 mouse cable
connect to
Mouse/Com