Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
Controlling the Projector
■ ■ ■ ■ ■
■
41
Using the Remote Control
To use the remote control, point it towards the remote
control receivers located at the front and back of the
projector.
To be able to use the remote control as a cordless mouse,
connect the mouse cable to the projector and your computer.
You can use the remote control up to 10 metres (33 feet)
from the projector.
♦
Note:
The projector may not respond to remote control
commands in these conditions: ambient light is too bright; a
certain type of fluorescent light is present; a strong light source
(such as direct sunlight) shines into the infrared receiver; or
other equipment emitting infrared energy is present (such as a
radiant room heater). Correct these conditions to use the remote
control or control the projector from a computer.
Power
Freeze
A/V Mute
E-Zoom
R/C ON
OFF
3
1
5
2
4
Enter
Esc
Esc button
Enter button
Remote control