Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
Turning the Equipment On and Off
■ ■ ■ ■ ■
■
35
Turning the Equipment On and Off
Turn on the projector and its attached equipment in the
following order.
1. Video source
2. Audio source (if different from computer or video source)
3. Projector
4. External speaker or PA system
5. Computer
When you turn off the equipment, do so in the reverse order.
Turning the Projector On and Off
1. Remove the projector lens cap.
2. When you plug in the projector power cord, the power
indicator flashes orange for few seconds. Then the light
remains orange.
3. Press the Power button on the remote control or
operation panel. The power indicator flashes green as the
projector warms up. When the projector is fully warmed
up, this light remains green.
If computer or video equipment is attached, the computer or
video signal is projected.
Allow about 30 seconds for full illumination.
♦
Warning:
Never look into the lens when the lamp is on. This can
damage your eyes. It is especially important that children are not
allowed to look into the lens.
♦
Caution:
When turning the projector on or off with the remote
control, be sure to turn the remote control on first with the power
switch.