Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
■
■ ■ ■ ■
24
1. Connect one end of the computer cable to the projector’s
Computer 1 port. (Use the Computer 2 port if you are
connecting a second computer.)
2. Remove the small cover on the Macintosh desktop adapter
and set its DIP switches in accordance with the resolution
you want to use (such as 16-inch mode). See your
Macintosh documentation for instructions.
3. Connect the small terminal of the Macintosh desktop
adapter to the other end of the video cable.