Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
Connecting to a Computer
■ ■ ■ ■ ■
■
23
Follow the steps in each section for the cables you need to
connect. Before beginning, turn off the projector and
computer if they are on.
♦
Note:
PowerBook configurations vary, so the location of your
computer’s ports may not match the illustrations. See your
PowerBook manual for the port locations if necessary.
Connecting the Computer Cable
First connect the computer cable. Refer to this illustration as
you follow the steps below.
♦
Note:
Some new PowerBooks may allow you to connect the
computer cable directly to the computer without using a
video-out cable. See your PowerBook manual for additional
information on connecting a computer cable.
Macintosh desktop
adapter
Computer 1 port
computer cable
video-out cable