Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
■
■ ■ ■ ■
22
Connecting the Audio Cable
1. If you will be using audio, connect one end of the audio
cable to the Audio 1 jack on the projector. (Use the Audio
2 jack if you are connecting a second computer.)
2. Connect the other end of the audio cable to the audio-out
port on your computer.
Connecting to a PowerBook
Your PowerBook must have video-out capability in order to
connect to the projector.
To connect the projector to your PowerBook, you need to:
• Connect the computer cable
• Connect the mouse and/or serial cable (if you want to use
the remote control as a mouse or use the ELP Link IV
software)
• Connect the audio cable (if you’ll be projecting with audio)
Audio 1 jack
audio cable