Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
Connecting to a Computer
■ ■ ■ ■ ■
■
21
2. To use the remote control as a wireless mouse, connect
one end of the projector’s Mac mouse cable or USB
mouse cable to the MOUSE terminal on the large end of
the main cable.
3. Disconnect your Macintosh’s mouse cable. Connect the
other end of the projector’s Mac mouse cable or USB
mouse cable to the mouse port on your Macintosh.
4. To use the ELP Link IV software or use the Effects button
on the remote control, connect one end of the Mac serial
cable to the Mac SERIAL terminal on the large end of the
main cable.
5. Connect the other end of the Mac serial cable to the
printer or modem port on the back of your
Macintosh.