Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
■
■ ■ ■ ■
18
2. Remove the small cover on the Macintosh desktop adapter
(as shown below) and set its DIP switches in accordance
with the resolution you want to use, such as 16-inch
mode. See your Macintosh documentation for
instructions.
3. Connect the small terminal of the Macintosh desktop
adapter to the other end of the computer cable.
4. Disconnect the monitor cable from the video port on the
back of the Macintosh. Then connect the computer cable
(with the Macintosh desktop adapter attached) to the
video port on the Macintosh.