Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
Connecting to a Computer
■ ■ ■ ■ ■
■
17
Connecting the Video and Monitor Cables
First connect the video and monitor cables. Refer to this
illustration as you follow the steps below.
1. Connect one end of the computer cable to the projector’s
Computer 1 port. (Use the Computer 2 port if you are
connecting a second computer.)
Macintosh
desktop adapter
Macintosh
monitor adapter
Macintosh
monitor cable
computer
cable
Computer Out port
Computer 1 port