Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
■
■ ■ ■ ■
16
Connecting the Audio Cable
1. If you will be using audio, connect one end of the audio
cable to the Audio 1 jack on the projector. (Use the Audio
2 jack if you are connecting a second computer.)
2. Connect the other end of the audio cable to your laptop.
Connecting to a Desktop Macintosh
To connect the projector to your desktop Macintosh, you
need to:
• Connect the computer cable and computer monitor cable
• Connect the mouse and/or serial cable (if you want to use
the remote control as a mouse or use the ELP Link IV
software)
• Connect the audio cable (if you’ll be projecting with audio)
Follow the steps in each section for the cables you need to
connect. Before beginning, turn off the projector and
computer if they are on.
♦
Note:
Macintosh configurations vary. See your computer
manual for the location of the ports needed to connect your
projector.
Audio 1 jack
audio cable