Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
■
■ ■ ■ ■
14
Refer to this illustration while following the steps below.
1. Connect the small end of the main cable to the projector’s
Mouse/Com 1 port. (Use the Mouse/Com 2 port if you
are connecting a second computer.)
2. To use the remote control as a wireless mouse, connect
the 9-pin end of the PS/2 mouse cable or USB mouse
cable included with the projector to the MOUSE terminal
on the square end of the main cable.
3. Connect the 6-pin (mini-DIN) end of the PS/2 mouse
cable to the external mouse port on your laptop.
Mouse/Com 1
port
9-pin serial
cable
PS/2 mouse cable
(or USB mouse
cable)
main cable