Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
Connecting to a Computer
■ ■ ■ ■ ■
■
13
Connecting the Video Cable
First connect the projector’s video cable to your laptop.
1. Connect one end of the computer cable to the projector’s
Computer 1 port. (Use the Computer 2 port if you are
connecting a second computer.)
2. Connect the other end of the video cable to the laptop’s
video (monitor) port.
3. Tighten the screws on all connectors.
Connecting the Mouse and Serial Cables
If you want to use the remote control as a mouse or use the
ELP Link IV software, you need to connect the main cable. It
provides connectors for:
1. The PS/2 mouse cable or USB mouse cable (to use the
remote control as a mouse)
2. The serial cable (to use the ELP Link IV software and the
Effects buttons on the remote control)
Computer 1 port
computer cable