Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
■
■ ■ ■ ■
10
Connecting the Mouse and Serial Cables
If you want to use the remote control as a mouse or use the
ELP Link IV software, you need to connect the main cable. It
provides connectors for:
• The PS/2 mouse cable or USB mouse cable (to use the
remote control as a mouse)
• The serial cable (to use the ELP Link IV software and the
Effects buttons on the remote control)
Refer to this illustration while following the steps below.
1. Connect the small end of the main cable to the projector’s
Mouse/Com 1 port. (Use the Mouse/Com 2 port if you
are connecting a second computer.)
Mouse/Com 1 port
main cable
9-pin serial cable
PS/2 mouse cable
(or USB mouse cable)