Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
■
■ ■ ■ ■
8
Connecting to a PC Desktop Computer
To connect the projector to your PC desktop computer, you
need to:
• Connect the computer cable and computer monitor cable
• Connect the mouse and/or serial cable (if you want to use
the remote control as a mouse or use the ELP Link IV
software)
• Connect the audio cable (if you’ll be projecting with audio)
Follow the steps in each section for the cables you need to
connect. Before beginning, turn off the projector and
computer if they are on.
♦
Note:
Computer configurations vary. See your computer
manual for the location of the ports needed to connect your
projector.
Connecting the Video and Monitor Cables
First connect the computer cable and computer monitor
cable. Refer to this illustration while following the steps
below.
Computer Out port
monitor cable
Computer 1 port
computer cable