Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover

■
■ ■ ■ ■
6
6. Insert the two AA batteries included with the projector.
Make sure the polarity of the batteries is correct.
7. Replace the battery compartment cover.
When replacing batteries, take the following precautions:
• Do not recharge the used batteries or expose to fire or
water.
• Replace batteries as soon as they run out. If the batteries
leak, wipe away battery fluid with a soft cloth. If fluid gets
on your hands, wash them immediately.
• Remove the batteries if you will not be using the projector
for a long period of time.