Owner`s manual

Introduction
■
■ ■ ■ ■
xii
Safety Instructions
Follow these safety instructions when setting up and using the
projector:
1. Do not place the projector on an unstable cart, stand, or
table.
2. Do not use the projector near water or sources of heat.
3. Use attachments only as recommended.
4. Use the type of power source indicated on the projector.
If you are not sure of the power available, consult your
dealer or local electricity company.
5. Place the projector near a wall outlet where the plug can
be easily unplugged.
6. Insert the projector’s three-pin grounding-type plug into
a properly grounded outlet. If you have a two-prong
outlet, contact an electrician to replace it. Do not handle
the plug with wet hands.
7. Take the following precautions when handling the plug.
Failure to comply with these precautions could result in
sparks or fire.
• Do not insert the plug into an outlet with dust present.
• Insert the plug firmly into the outlet.
8. Do not overload wall outlets, extension cords or integral
convenience receptacles. This can cause fire or electric
shock.
9. Do not place the projector where the cord can be stepped
on. It may result in fraying or damage to the plug.
10.Unplug the projector from the wall outlet before cleaning.
Use a damp cloth for cleaning. Do not use liquid or
aerosol cleaners.