Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
Replacing the Lamp
■ ■ ■ ■ ■
■
87
4. Use the screwdriver, coin, or similar object to loosen the
two screws holding the lamp unit in place. (You cannot
remove these screws.)
5. Lift up the handle and pull out the lamp unit.
6. Gently insert the new lamp unit by lowering it into
position. Make sure it is inserted securely.
7. Tighten the screws you loosened in step 4.
8. Replace the lamp cover and tighten the cover screws.
(Make sure the lamp cover is securely fastened. The
projector turns itself off if the lamp cover is open.)
2
1