Owner`s manual
Table Of Contents
- Front Cover
- Important Information
- QUICK START
- Contents
- Introduction
- Installation
- Using the Projector
- Using the Projector Menus
- Using the ELP Link IV Software
- Presentation support function
- Projector setting function
- System requirements
- Projector Software CD-ROM
- Connecting the Cables
- Installing the Projector Software on Your PC
- Installing the Projector Software on Your Macintosh
- Accessing the Projector Software
- Installing or Accessing the Projector Software on the CD-ROM Directly
- Maintenance
- Troubleshooting
- Technical Specifications
- Glossary
- Index
- After sales service contact addresses
- Back Cover
■
■ ■ ■ ■
86
Replacing the Lamp
Replace the lamp when:
• The projected image gets darker or starts to deteriorate.
• The projection lamp indicator is flashing orange.
• The message "LAMP REPLACE" appears on the screen
when the projector lamp comes on.
♦
Note:
To keep the initial brightness and image quality, replace
the lamp as soon as possible when the message appears on the
screen. The replacement message is set to being displayed at about
1500 hours of use. Contact your local EPSON dealer for a spare
lamp. Request part number ELPLP09.
♦
Warning:
Let the lamp cool before replacing it. Also, do not
touch the glass portion of the lamp assembly. Touching the glass
portion of the lamp will result in premature lamp failure.
1. Turn off the projector and unplug the power cable.
2. Turn the projector over so you can access the lamp cover.
3. Use a screwdriver, coin, or similar object to loosen the
two retaining screws on the lamp cover. When the screws
are loose, lift off the lamp cover. (You cannot remove
these screws from the cover.)
2
1