Specifications

10
9. Can I adjust the printer for feed length and do I need to do this?
Yes, The EFI RIP has an adjustment to compensate for feed length of the Printer because each printer
may feed slightly differently. It is HIGHLY recommended that you adjust for this when you first install the
printer and the RIP and it should not need to be adjusted
again. The adjustment is specfied in the
“Preferences” window under the “printer” tab and “media Size” sub-tab as shown below:
The correct process is to enter the target value (430 mm above) and the actual length (430 mm to
start). Then, print an alignment sheet that has the included 430 mm line. Measure the line after the
printing is complete and then enter the ACTUAL number you measure to the 0.xx mm. Here is the 430
mm line on the alignment sheet (outlined in red):