Specifications

Epson PowerLite 755c/765c Projector
14 - Epson PowerLite 755c/765c Projector 8/05
Access point mode: On the General tab, select
Internet
Protocol, then click the Properties button. You see this
screen:
9. If your access point uses DHCP, select
Obtain IP address
automatically
. Otherwise, select Use the following IP
address
and enter the required information.
❏
IP address: Type in the IP address you want to assign to
the computer. It must be formatted like other addresses
on the network; usually the first three sections
(XXX.XXX.XXX) match the access point’s IP address,
and the last section is unique.
❏
Subnet mask: For example, 255.255.255.000, but this
too must match how your network is set up.
❏
Default gateway: Enter the IP address that was assigned
to the access point when it was set up.
10.When done, click
OK.
11.Click the
Wireless Networks tab. You see this screen:
Note:
If you don’t see this tab, you may need to enable your wireless
card or network device by clicking
Configure to access the
device settings; then follow any instructions on the screen to
enable the device.
12.Verify that you’ve enabled your computer’s connection to
the access point. It should be listed as shown above, with the
small icon next to it, indicating a connection.
If it’s not listed, click
Configure and then type the name of
your access point.
13.When you’re done, click
OK. Continue with “Projecting
Wirelessly” on page 15.
Checking the Gateway (Access Point’s) IP Address
If you’re entering IP addresses manually in access point mode
and need to find out the gateway IP address (the IP address of
your access point), make sure the wireless connection to the
access point is currently active, as described in the previous
section.
Note:
If you can’t identify the gateway address using this Windows utility,
use the administrator’s utility software that came with your access
point.
1. Access your wireless network Properties window. For
example, in Windows XP click
Start > Control Panel >
Network and Internet Connections
. Then
double-click the
Network Connections icon.
2. Right-click the
Wireless Network Connection icon and
select
Status. Then click the Support tab.
The gateway’s (access point’s) IP address is listed as shown:
Gateway
address