Specifications

Epson PowerLite 755c/765c Projector
12 - Epson PowerLite 755c/765c Projector 8/05
4. Select either
Easy connect mode (for ad hoc) or Access
point mode.
You see one of these screens:
5. Make sure the projector has a unique name so you can
identify it when connecting to it from your computer.
Use the pointer button on the remote control to
highlight the Projector Name text box, then press
Enter.
The text box turns yellow to indicate you’re in input mode.
Press the pointer button up to select individual letters in
alphabetical order, or down to select letters in reverse order.
Then press the pointer button to the right to move to
the next character position. When you’re done typing the
new name, press
Enter.
To enter numbers, press and hold the Num button on the
remote control while pressing number buttons on the
numeric keypad. Press the
Num button again to exit
numeric keypad mode. When you’re done, press
Enter.
6. Select the appropriate settings for your mode, described in
the following table.
7. When you’re done making settings, highlight the
OK button
at the top of the screen. Then press
Enter. Highlight the OK
button again and press
Enter to return to the main EasyMP
Network Screen.
Ad hoc
mode
Access
point
mode
ESSID Ad hoc: Enter an ESSID in the ESSID
textbox.
Access point: Enter an ESSID, which is
the SSID name of your access point or
the name of your AirPort network. (The
name of your AirPort network may be
different from that of your AirPort base
station; select your base station in the
AirPort Admin utility and click
Configure
to check the name of your network.)
Note that the ESSID is case-sensitive.
Password for WEB
control
If you want to create a password for an
internal web page, you can enter up to
8 alphanumeric characters.
Projector keyword Turn this option on if you want to set up
a security keyword so that only people
in the same room as the projector can
access it. When you connect to the
projector wirelessly, it displays a four-
digit randomized keyword on the
screen that you need to enter when
prompted.
DHCP (access point
mode only)
If your access point assigns IP
addresses automatically, turn this
option on. Otherwise, turn it off and
assign an IP address, subnet mask, and
gateway address manually.
IP address (access
point mode only)
Enter the IP address you want to assign
the projector. It must be formatted like
other addresses on the network;
usually the first three sections match
the access point’s IP address. The last
section should be unique.
Subnet mask (access
point mode only)
Enter a subnet mask formatted like
other subnet masks on your network.
Gateway address
(access point mode
only)
Enter the IP address that was assigned
to your access point or AirPort base
station when it was set up. If you don’t
know the address, see “Checking the
Gateway (Access Point’s) IP Address”
on page 14.