Specifications

REV.-A
CBB(C) (M3X 10) Screws
CB
(M3X8)’Screw BOARD ASSY., MAIN
Figure 3-7. BOARD ASSY.,MAIN
Adjustment Required
When replacing the BOARD
ASSY.,MAIN, you must adjust the bidirectional print position again
to ensure bidirectional printing is mrrectly aligned
<Bidirectional Print position
adjustment(See section 4.2)>
3.2.3,2
Removing the BOARD ASSY.,POWER SUPPLY (C082 PSB/PSE Board)
1.
2.
3.
4.
)
Remove the HOUSING ASSY.,UPPER (see Section 3.2.2.2).
Remove the cable from the connector CN13 of the BOARD ASSY.,MAIN.
Remove the cable for connector
CN1 of the BOARD ASSY.,POWER SUPPLY.
Remove five CBB(C) (M3 X 10) screws and the CB (M3 X 8) screw that hold the BOARD
ASSY.,POWER SUPPLY to the HOUSING ASSY.,LOWER. Remove the BOARD ASSY.,
POWER SUPPLY.
BOARO ASSY., POWER SUPPLY (C062 PSB/PSE 60sd)
CBS(C) (M3 X 10) Screws
Figure 3-B. Removing the BOARD ASSY.,POWER SUPPLY
3.2.3.3 Removing the BOARD ASSY.,PANEL(C082 PNL Board)
1. Remove the HOUSING, FRONT (see Section 3.2.2.1).
2. Remove five
CBB(C) (M3 X 10) screws that hold the BOARD ASSY.,PANEL to the
HOUSING, FRONT. Remove the BOARD
ASSY.,PANEL.
Figure 3-9. Removing the BOARD ASSY.,PANEL
3-8