Specifications
REV.-A
3.2.3 Removing the Circuit Boards
)
This section describes how to remove the BOARD
ASSY.,MAIN
(C107
MAIN board), the BOARD
ASSY.,POWER SUPPLY
(C062
PSB/PSE board) and the BOARD ASSY.,PANEL
(C062
PNL board).
3.2.3.1 Removing the BOARD
ASSY.,MAIN (C107 MAIN Board)
1.
2.
3.
4.
5.
6.
)
7.
Remove the HOUSING ASSY.,UPPER (see Section 3.2.2.2).
Remove the
CB
(M3 X 6) screw that hold the HOLDING PLATE,FFC to the SHIELD PLATE,MAIN
BOARD, and remove it.
Disoonneot the FFC(CABLE,HEAD, FRONT(REAR)) removing the
oables
for the CN6 and CN7
mnneotors
on the BOARD ASSY.,MAIN.
Remove three
CBB
(C)
(M3
X 10) sorews that hold the SHIELD
PLATE,MAIN
BOARD to the BOARD ASSY.,MAIN, and remove it.
[
CBB(C)
(M4x
14) Screw
SHIELD PLATE,
RIGHT>
C!
CBB
(M4X 10) Screw
-
cCB
(M3X6)
Screw
lliE%&2-
~ MAIN BOARD
/
BOARD ASSY., MAIN
CBB(C)
(M3X 10) Screws
Figure 3-6. Removing the Shield Plate, MAIN BOARD
Remove the
CBB
(M4 X 10) sorew that hold the SHIELD PLATE, RIGHT to the BOARD
ASSY.,MAIN.
Remove the CBB(C)(M4 X 14) screws that hold it to the
HOUSING ASSY.,LOWER. Remove the SHIELD PLATE, RIGHT.
Remove the cables from the following connectors on the main board:
CN3
(brown 12-pin), CN4
(white 5-pin),
CN5
(white 6-pin), CN8 (yellow 2-pin), CN9 (black 2-pin), CN1O (blue 2-pin),CN11
(white 2-pin) and CN12 (red 2-pin).
Remove three
CBB(C)
(M3
X 10) screws and CB A-IAMITITE
(M3
X 8) sorew that hold the
h
board to the lower
~sej
Remove the main board.
CAUTION
Be
oareful
with a color of the harness cable when you connect them to the mnnector
CN1l
and
CN12 of the Main board. The connect connection should be as below.
Hamess(BLACK)+CNl
1(WHITE)
Hamess(GRAY)+CN12(WHlTE)
3-7