Specifications

REV.-A
~- 1.5 DIP SWITCHES AND JUMPER SETTING
This section describes the DIP switch selections and jumper setting for the LQ-570+ printer.
1.5.1 DIP Switch Setting for ESC/P 2 mode
This printer is”equipped with two banks of DIP-SWITCHES and they are located on the control panel. The tablel -12
through 1-15 shows the available function settings of two DIP switches. (Note that the status of the DIP switches
is only read at power on or upon receipt of the
/lNIT signal.)
Table 1-12. Settinas for DIP Switch 1 EW1)
No.
1
2
3
4
5
6
7
8
Description
International character set and PC
table selection
Character table selection
Graphic print direction
Comand Ianguage’1
Inmd buffer
l-inch skip perforations
ON
OFF
Factory
Setting
See the table 1-14
ON
ON
OFF
GraDhic I
Italic
OFF
Unidir.
Bidir.
OFF
IBM
ESC/P2
OFF
OKB
8KB
OFF
ON
OFF
OFF
NOTE: : *1 is European version only. The switch of 1-6 is invalid for another versions.
Table 1-13. Settings for DIP Switch 2 (SW2)
No.
Description
ON
OFF
Factory
Setting
1
Page length of continuous paper
See Table 1-15 below.
OFF
2
OFF
3
Auto tear-off
ON
OFF
OFF
4
Auto LF
ON
OFF
OFF
1-18