Owner's manual
Table Of Contents
- Front Matter
- Contents
- Welcome
- Chap 1-Setting Up the Projector
- Chap 2-Using the Projector
- Chap 3-Using the Remote Control
- Chap 4-Fine-tuning the Projector
- Chap 5-Maintaining and Transporting the Projector
- Chap 6-Solving Problems
- Appendix A: Connecting to Additional Equipment
- Appendix B: Notices
- Appendix C: Technical Specifications
- Index
16
Setting Up the Projector
Connecting S-Video
If your video source has an S-video jack, you can use it to project a
higher quality video image. However, you’ll need an S-video cable,
which may be included with your video source, or may be purchased.
Before starting, make sure the projector and your DVD player or
other video source are turned off.
1. Insert one end of an S-video cable into the projector’s
S-Video
connector.
2. Insert the other end into the S-video output port of your video
source.
3. Connect the RCA A/V cable to the left and right
Audio
jacks on
the projector. (Match the red and white plugs to the red and
white jacks; you won’t need to use the yellow plug.)
4. Connect the plugs at the other end of the cable to the audio
output jacks on your video source.
S-Video cable