User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-INSTALLATION
- CHAP 2-USING THE PROJECTOR
- CHAP 3-USING THE PROJECTOR MENUS
- CHAP 4-USING THE ELP LINK II SOFTWARE
- CHAP 5-MAINTENANCE
- CHAP 6-TROUBLESHOOTING
- CHAP 7-TECHNICAL SPECIFICATIONS
- GLOSSARY
- INDEX
1 • Installation
18
2.Connect the main cable. The main cable connects the mouse cable
(needed to use the remote control as a mouse) and serial cable
(needed to use the ELP Link II software) from your Macintosh to
the projector.
a. Connect the small end of the main cable to the projector’s
Mouse/Com 1 port. (Use the Mouse/Com 2 to connect a
second computer.)
b. Connect the MAC mouse cable to the mouse terminal on the
other end of the main cable.
main cable
MAC mouse
cable
MAC serial
cable
pro-ch1.fm Page 18 Friday, November 7, 1997 5:22 PM