User`s guide
Table Of Contents
- FRONT MATTER
- CONTENTS
- INTRODUCTION
- CHAP 1-INSTALLATION
- CHAP 2-USING THE PROJECTOR
- CHAP 3-USING THE PROJECTOR MENUS
- CHAP 4-USING THE ELP LINK II SOFTWARE
- CHAP 5-MAINTENANCE
- CHAP 6-TROUBLESHOOTING
- CHAP 7-TECHNICAL SPECIFICATIONS
- GLOSSARY
- INDEX
Replacing the Lamp
85
3.Use a screwdriver, coin, or similar object to loosen the two
retaining screws on the lamp cover. When the screws are loose, lift
off the lamp cover. (You cannot remove these screws.
)
4.Use a screwdriver, coin, or similar object to loosen the two screws
holding the lamp in position. (You cannot remove these screws.)
pro-ch5.fm Page 85 Friday, November 7, 1997 5:24 PM