User guide

Removing an Option Card
..................... 4-18
Removing the Option Card Connector Board
..........
4-18
Replacing the Option Card Connector Board
..........
4-20
Adding Video Memory
.......................
4-21
Installing the Video Chips
..................
4-21
Installing External Cache
......................
4-23
Installing the Chips
......................
4-24
Upgrading the Microprocessor
..................
4-26
Replacing the Processor Chip
................
4-27
Installing a Heat Sink
.....................
4-29
Post-installation Procedures
....................
4-29
Chapter 5
Installing and Removing Drives
Installing a Hard Disk Drive in the Internal Drive Bay . . . . . 5-2
Removing the Mounting Frames . . . . . . . . . . . . . . . 5-3
Connecting the Hard Disk Drive Cables . . . . . . . . . . 5-4
Installing the Hard Disk Below the Mounting Bracket . . 5-8
Installing the Hard Disk On the Mounting Bracket . . . . 5-10
Removing a Hard Disk Drive From the Internal Drive Bay . . .
5-13
Installing a Drivein the Upper External Drive Bay . . . . . . . 5-13
Connecting the Drive and Power Cables . . . . . . . . . . 5-16
Removing a Drive from the Upper Drive Bay . . . . . . . . . . 5-18
Reconnecting the Drive and Power Cables to the Diskette
Drive in the Lower Drive Bay . . . . . . . . . . . . . . . . . .
5-18
Post-installation Procedures . . . . . . . . . . . . . . . . . . . . 5-20
Chapter 6
Installing VGA and IDE Drivers
VGA Drivers
.............................
6-1
Installing the Windows Drivers
...............
6-3
Configuring the Drivers
....................
6-3
SetRES
..............................
6-4
IDE Drivers
..............................
6-5
Installing the IDE Drivers
...................
6-5
ix