Service manual

LQ-2070 Service Manual
Product Description
1.4.7 Default Setting Function
Pressing the Pitch button while turning on the printer puts the printer in default setting mode.
Some default printer settings can be changed in this operation. The method for setting defaults is
described in the instruction sheets, which are printed out immediately after you enter the mode.
You are asked to use three buttons (Font, Condensed, and Tear Off/ Bin) and watch six LEDs
(Condensed: 3 LEDs, Tear Off/Bin: 2 LEDs, and Pause: 1 LED) on the control panel. Refer the
instructions printed in default setting mode for the actual method used to set defaults.
1.4.8 EEPROM Clear Function
Pressing the Font and Tear Off /Bin buttons while turning on the printer resets the EEPROM to the
standard factory settings. This operation initializes the iterns below to the factory settings in the
right-hand column.
Table 1-45 EEPROM Initialization Settings
Setting
I
Factory Default
Font
I Roman
Condensed
10
CPI
Character Table
PC437
Page Format Page Length: 11 inches
( Tractor Rear/ Front) TOF Position: 8.5 mm (0.333 inches)
Bottom Margin : 11 inches
Page Format Page Length:
22 inch
(Friction , CSF Bin 1 / Bin 2,
TOF Position:
8.5 mm (0.333 inch)
Manual Feed Rear/ Front )
Bottom Margin: 22 inches
Print Direction
Bi-d
Auto LF
off
Auto Tear-Off
off
l-inch Skip
off
High Speed Draft
On
Input Buffer
On
BDC-ST Reply
off
l/F Selection
Auto l/F Mode
Auto l/F Wait Time
10 sec.
Software
ESCIP2
Slashed Zero
off
Buzzer
On
Auto CR ( IBM Mode)
off
Adjust Tear-Off Position
O inch
Paper Conditions
Friction: Bin 1, Tractor: Tear-Off: Status Off
Rev.A
1-33