Service manual

4.2.2.2 Bi-d Print Alignment Adjustment from the Control Panel
1. Turn the printer on while pressing the PAUSE button to put the printer into Bi-D adjustment
mode.
2. The printer prints out a guide sheet, containing 25 patterns in Draft mode.
3. Look for the pattern most closely aligned on the sheet.
4. Press the LF/FF or LOAD/EJECT button until the lights match those for the best-aligned pattern on the
guide sheet.
5 Press the FONT button to save your selection. The printer then prints 25 patterns in Draft Copy print mode
on the additional pages.
6. Return to step 3 of this procedure to adjust the bidirectional alignment in Draft Copy mode.
7. After you perform steps 3 to 5 above for Draft Copy mode, go back to step 3 to adjust NLQ mode.
8. When you have made your last selection in NLQ mode, turn the printer off to finish the
adjustment.
To adjust your printer, follow these steps
1. Look for the alignment pattern that is most closely alignment and press the LF/FF or the Load/Eject button until
the lights indicate the appropriate pattern number as shown below.
2. Press the Font button to resister your selection. The printer prints additional pages that display alignment
patterns.
3. When you have made your last selection (sheet LQ), turn the printer off.
1 14
2 15
3 16
4 17
5 18
6 19
7 20
8 21
9 22
10 23
11 24
12 25
13
Draft
No, 1
No, 2
Pattern number
Font LEDs
Figure 4-10 Guide Sheet for Bi-d Adjustment
Adjustment LQ-2070 Service Manual
4-6 Rev.A