Service manual

3.3.3 Removing the Paper Eject Assembly Cover
1. Remove the paper eject assembly cover by releasing 2 clips located along both edges of the paper
eject assembly cover, as shown in the following figure.
When attaching the paper eject assembly cover to the CSF unit, pay attention to the position of 2
pieces of thin plastic film glued on the reverse side of the paper eject assembly cover, as shown in
the following figure.
Gear Train Cover
Figure 3-48 Removing the Gear Train Cover
Gear (22mm)
White Gear ( 22mm)
Combination Gear ( 25 mm/11mm)
CSF Planetary Lever Assembly
CSF Transmission Gauge
Spring
Plain Washer
Figure 3-49 Engaging 5 Gears
LQ-2070 Service Manual Disassembly and Assembly
Rev.A 3-31