Service manual

EPSON Stylus Photo R1900/R2880/R2000 Revision E
Disassembly And Assembly Disassembling the Printer Mechanism 94
Confidential
8. Peel off a piece of acetate tape and disconnect the CSIC FFC from the connector
on the CSIC Board.
9. Disengage the Cable Holder from the hook and remove it.
Figure 4-55. Removing the CSIC Assy (1)
10. Using the special tool (see p.71) disengage the two hooks of the CSIC Assy on the
right and left on the rear of the Carriage Unit and remove the CSIC Assy upward.
Figure 4-56. Removing the CSIC Assy (2)
C A U T I O N
Before performing the following procedure, be sure to disconnect
the CSIC FFC from the connector on the CSIC board. If not, the
CSIC Assy can not be removed, and the CSIC FFC may be
damaged.
Cable Holder
Hook
Connector
CSIC FFC
Acetate tape
CSIC Assy
CSIC Assy
Hooks
Rear of Carriage Unit
Hooks