Service manual

EPSON Stylus Photo R1900/R2880/R2000 Revision E
Disassembly And Assembly Removing the Housings 79
Confidential
3. Disengage the nine hooks on the bottom of the Panel Unit, and remove the Panel
Unit while pulling out its tab.
4. Remove the Panel FFC from the Panel Unit. Refer to Figure 4-15.
5. Disconnect the Panel FFC and CDR Sensor cable from the Panel Board connectors
and remove the Panel Unit.
Figure 4-14. Removing the Panel Unit (2)
Hook
Tab
Connector
CDR Sensor
cable
Panel FFC
Panel Unit
 Be careful not to get the Panel FFC caught underneath the
hooks on the Panel Unit.
 Secure the Panel FFC with double-sided Tape on the Panel
Unit.
 Route the CDR Sensor cable as shown in the following figure.
Figure 4-15. Reinstalling the Panel Unit
Panel FFC
CDR Sensor cable
Double-sided Tape