Service manual

EPSON Stylus Photo R1900/R2880/R2000 Revision E
Disassembly And Assembly Disassembling the Printer Mechanism 125
Confidential
4.4.16 Release Holder Assy
1. Remove the APG Assy. (p.89)
2. Release the PE Sensor connector cable from the five tabs on the Release Holder
Assy.
3. Remove the three C.B.S. M3 x 6 screws that secure the Release Holder Assy.
4. Remove the three lower tabs of the Release Holder Assy from the Main Frame
with a flathead screwdriver, and remove the Release Holder Assy upwards.
Figure 4-148. Removing the Release Holder Assy
2) C.B.S. M3x6
(8±1 kgf.cm)
1
2
3
PE Sensor connector cableTabs
Release Holder Assy
Rear side
Upper Tabs
Lower Tabs
Front side
 Align the three upper tabs on the Release Holder Assy with the
positioning holes on the Main Frame. See Figure 4-148.
 Fit the FLAG Release Shaft by the bushings on the Release
Holder Assy.
Figure 4-149. Reinstalling the Release Holder Assy
 Tighten the screws in the order shown in Figure 4-148
Bushings
FLAG Release Shaft