Service manual

EPSON Stylus Photo R1900/R2880/R2000 Revision E
Disassembly And Assembly Disassembling the Printer Mechanism 113
Confidential
9. Remove the C.B.S. M3 x 6 screw that secures the Right CDR Tray Base Support,
and remove the Right CDR Tray Base Support.
Figure 4-108. Remove the CDR Tray Base Support
10. Remove the E Ring that secures the CDR Tray Base and remove the CDR Tray
Base in the direction of the arrow.
Figure 4-109. Remove the CDR Tray Base
2) C.B.S. M3x6
Right CDR Tray Base Support
CDR Tray Base
E Ring
 Hook both rear ends of the Paper EJ Frame Assy onto the tabs
on the Main Frame.
 Align the bearing of the CDR Release Level Sub Assy with the
Paper EJ Release Shaft.
Figure 4-110. Reinstalling the Paper EJ Frame Assy
 Attach the LABEL,CAUTION,CDR;B (parts code:1470311) at
the position as shown below.
Figure 4-111. Attaching Position of the CDR Caution Label
 Match the tabs with the five positioning holes.
See Figure 4-106.
 Tighten the screws in the order shown in Figure 4-107
A D J U S T M E N T
R E Q U I R E D
After replacing or removing the Paper EJ Frame Assy, always make
the required adjustments referring to the following.
 “Chapter 5 Adjustment (p.137)”
Shaft and
Bushing
Shaft and
Bushing
Tabs
LABEL,CAUTION,CDR;B
34mm
2mm