Service manual

EPSON Stylus Photo R1900/R2880/R2000 Revision E

Disassembly And Assembly Disassembling the Printer Mechanism 107

Confidential

9. Remove the two C.B.S. M3 x 6 screws that secure the two Guide Roller LDs.

10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the Guide

Roller LDs.

Figure 4-95. Removing the Guide Roller LD

11. Remove the three C.B.S. (P4) M3 x 8 screws that secure the ASF Assy, and

remove the ASF Assy from the Printer Mechanism.

Figure 4-96. Removing the ASF Assy

Referring to Figure 4-93, correctly route each of the cables and

FFCs.

C H E C K

P O I N T

When only removing the ASF Assy, you do not need to perform

"5.2.5 ASF Guide Roller LDs Position Adjustment (p159)". In that

case, mark the installing positions of the Guide Roller LDs before

removing them, and make sure to align the markings when

installing the Guide Roller LDs.

Figure 4-94. Marking Position

Front

Face

2) C.B.S. M3x6

(8±1 kgf.cm)

Guide pin

Tab

LD Roller Shaft

Guide Roller LD

Align the guide pins and tabs on the Guide Roller LDs with the

positioning holes on the Main Frame. (Refer to Figure 4-95.)

6) C.B.S. (P4) M3x8

(6±1 kgf.cm)

ASF Assy

6) C.B.S. (P4) M3x8

(6±1 kgf.cm)