Installation manual

• ACC. hook-up and 12VDC hook-up
– First locate the ACC. position on the fuse box by using a trouble light or a volt meter.
– With the truck turned OFF, connect the test light, by connecting the alligator clip to ground.
Use the other end of the test light to touch the end of the fuse.
• Note: The test light will light when you come in contact with a 12 volt source.
– After locating an ACC. line, test to ensue that it is a true ACC.
• Note: If it is a ACC. Line the test light will go On and OFF as you turn the key from
the OFF to ACC. Position, connect the Green wire from terminal strip the ACC. Fused
position to the.
– Locate Black Cable attach the White wire to the Truck Battery ( Positive ) and the Black
wire to the (Negative) or chassis ground. Keep in mind that the wire should be routed out of
the way of foot traffic and where it will not be cut. .
CAB HOOK-UP
Note: When routing the cable to the fuse box, use care to keep it out of the way of foot traffic. A
recommended route for the cable is under the floor mat behind the driver’s seat and down
through the door channel to the fuse box. The floor mat will provide protection to the cable
and the channel will keep it safe from foot traffic.