Installation manual

• Wiring Cables
– To make the installation easier, each F-RAMS
®
is shipped with 3 quick connect
wiring cables. This kit is made up of several cables.
– (1) MCU wiring cable ------ 3 conductor 18 gage ( White --- 12VDC,Green ---
ACC, and Black --- GND ) Note: Runs from the fuse box and the terminal strip.
– (2) I.S. Power Supply wiring cable ----- 2 conductor 18 gage (Green --- ACC
and Black --- GND ) Note: 1 cable runs between the fuse box and the terminal strip
and the Second cable between the terminal strip and the IS Power Supply.
– (1) Pair Fiber Optic communication cable ---- 2 conductor Blue / Orange
(runs between MCU and the RDU which is located on the back of the truck)
–
(1)
Single Valve Fiber Optic
cable
-----
1 conductor / Blue ( runs between
CABLES
–
(1)
Single Valve Fiber Optic
cable
-----
1 conductor / Blue ( runs between
the Valve control box and the RDU )
– Note : Only need if Valves are on the truck
– (1) Valve cable ---- 2 conductor 18 gage ( White --- 12VDC and Black --- GND )
Note: runs between the truck cab and the valve control box.
– (2) Ground Straps ( Braided ) MCU to I.S. Barrier
– Note : Only need if Valves are on the truck
Installation Note: Use caution to avoid damaging the insulation on the
individual wires.