User`s guide

Printing on Special Media
3-18
Removing Continuous Paper
When you’ve finished printing a continuous paper document,
you must carefully follow these steps to remove it from the
printer, depending on your media type and the setting of the
auto tear-off feature.
1. If the printer’s auto tear-off feature is turned on, your
continuous paper is automatically advanced to the tear-off
position at the end of a print job. Go to step 2.
If the auto tear-off feature is turned off (the default setting),
press the
LF/FF button as many times as necessary to
advance the last printed sheet to the tear-off edge. Go to
step 2.
If the auto tear-off feature is turned off (the default setting)
and you’re printing labels, tear off the next sheet of labels at
the back of the printer. Then press the
LF/FF button on the
printer’s control panel as many times as necessary to eject
the remaining pages forward out of the printer. Do not
perform steps 2 and 3.
Note:
See Chapter 5 for
information on using
default-setting mode to
change the auto tear-off
setting for your print job.
media.fm5 Page 18 Friday, May 9, 1997 1:48 PM