User`s guide

Printing on Special Media
3-16
9. Slide the right sprocket to the approximate width of your
paper. Then position the center support midway between
the two sprockets, as shown in the previous illustration.
10. Flip open both sprocket covers.
11. Arrange the continuous paper stack so the printable side is
face up. Fit the first four holes over the sprocket pins on
both sprockets; then close the sprocket covers.
12. Slide the right sprocket to remove any slack in the paper.
Then press down the sprocket-lock lever to lock it in place.
If necessary, align your stack of continuous paper so it will
feed straight into the tractor feeder.
Note:
The maximum printable
width is 13.6 inches
(345 mm) on any size
paper.
sprocket covers
media.fm5 Page 16 Friday, May 9, 1997 1:48 PM