Service manual

Engine-power assembly
1 Remove the following assemblies
Right-side cover. See
Right-side cover on page 75.
Left-side cover. See
Left-side cover on page 77.
Top-cover assembly. See
Rear panel and top-cover assembly on page 77.
Front cover. See
Front cover on page 82.
2 Disconnect six cables (callout 1) near the top of the power assembly.
CAUTION Do not pull directly on the wires when a connector is disconnected. Always pull
on the plastic body of a connector to avoid damaging the connector wires.
3 Remove four screws (callout 2).
1
2
Figure 5-24 Remove the engine-power assembly (1 of 2; HP LJ 1020 printer shown)
ENWW Internal assemblies 87