Service manual

2 The clamps on the paper guide fit over the bearings on the right and left ends of the transfer roller.
Do not touch the black-sponge portion of the transfer roller. Grasp the right end of the paper guide
and pull the clamp off the right bearing. Slide the paper guide slightly to the right, and the left clamp
will slide off the left bearing.
Figure 5-22 Remove the transfer roller (2 of 3)
3 Use needle-nose pliers or your fingers to squeeze the two small tabs on the transfer roller.
Figure 5-23 Remove the transfer roller (3 of 3)
4 Angle the transfer roller up while holding on to the gear on the right side. Slide the roller toward right
side of the printer, and lift both the transfer roller and the transfer-roller guide out of the printer.
ENWW Internal assemblies 85