Service manual

Left-side cover

Removing the left-side cover is similar to removing the right-side cover. Use the steps and figures for

removing the right-side cover, except start the procedure by examining the tabs on the left side and

removing the screw on the left side.

NOTE If the cover cannot be removed easily, release one additional tab that is located on the

bottom of the printer near the center of the cover.

Rear panel and top-cover assembly

NOTE This procedure removes the rear panel and the top-cover assembly (the assembly

consists of the print-cartridge door and the fuser cover).

1 Remove the following assemblies.

● Right-side cover. See

Right-side cover on page 75.

● Left-side cover. See

Left-side cover on page 77.

2 Open the print-cartridge door.

3 Remove two screws from the top of the printer (callout 1).

Figure 5-10 Remove the rear panel and top-cover assembly (1 of 6)

ENWW Covers 77