Service manual

8 Disconnect one flat flexible (ribbon) cable and the connector to the step motor (callout 4). Remove
two screws (callout 5). Loosen the tape (callout 6) that secures the cable to the chassis. As you
remove the ECU, unplug the additional connector to the laser/scanner assembly.
CAUTION Do not pull directly on the wires when a connector is disconnected. Always pull
on the plastic body of a connector to avoid damaging the connector wires.
5
6
4
Figure 5-34 Remove the ECU assembly (6 of 6)
Reinstallation tip When reinstalling the ECU metal casing, make sure that the laser/
scanner shutter lever is inserted correctly through the plastic guide.
ENWW Internal assemblies 95