Service manual

Fuser (fixing) assembly
1 Remove the following assemblies.
● Right-side cover. See
Right-side cover on page 75.
● Left-side cover. See
Left-side cover on page 77.
● Top-cover assembly. See
Rear panel and top-cover assembly on page 77.
2 Disconnect cables, as necessary, from near the top of the engine-power assembly, and disconnect
the high-voltage wire (callout 1) from the back of the printer.
CAUTION Do not pull directly on the wires when a connector is disconnected. Always pull
on the plastic body of a connector to avoid damaging the connector wires.
1
Figure 5-26 Remove the fuser (fixing) assembly (1 of 2)
3 Remove the wire harnesses from the plastic harness retainers.
ENWW Internal assemblies 89