User Manual

23
promoted if adjusted and save operated successfully.
Input Password
000000
Save Cancel Save success!
NOTE：The log after the current time will be erased when the clock have be
adjusted.
 Device Parameter
There are 2 interfaces about device parameter as shown blew:
You should input the user password (see above) before setting the
parameters.
The first interface shows the 4-digit controller‘s ID in networking and keeps the
ID number unique in the networking or PC software or other device(s) couldn‘t
search it.
The second interface shows the backlight time.
Item
The set range
Default
Backlight Time
1 to 90 seconds
60 seconds
Storage Interval
1 to 30 minutes
10minutes
NOTE: The backlight time ―–‖ means that the backlight is never off.
 Load Mode
Load Mode can be set through each menu item respectively.
Manual(default)
◎ Light On/Off
◎ Light On+Timer
◎ Time
√Manual
Manual Control
ON
The default load output can be set ON/OFF in this interface. Parameters in the
table below:
Local ID
T03-0001
Backlight Time
60 s
Storage Interval
10min