User Manual

81
The following error situations are conceivable:
Remedy
– Motor axes move in wrong direction or do not
match joystick movement.
– Check installation matches motor
module setup, e.g. left side mounting
etc.
– Some user actions are not possible. – Perform a reset or general reset and
then reinstall the device (section
5.4.3).
– Device not responding to key presses,
Home function still active.
– Move joystick or press "Home" key
again,
tool moves downwards.
–Tool does not move forwards or back or
forward/back (in X and Y direction) when
joystick is moved, only to side.
– Deactivate Z only function.
– When connected, no LED is lit on the device
and the device will not switch on
– Reset, General-Reset,
Unplug mains power cable.
Check mains cable and plug.
If mains power supply unit defective:
Service
– An error message or warning in the form of
an 8-tone acoustic signal is delivered.
– Check all cable connections.
Rest, General-Reset,
Unplug mains power cable.
If the problem has not been
eliminated, or if it recurs: Service
Troubleshooting
7 Troubleshooting
7
07_Fehler_e.fm Seite 81 Dienstag, 16. August 2005 3:19 15