Owner manual

epBlue Application Editor - Creating and editing applications
epBlue™ with MultiCon
English (EN)
82
6.5.1.2 Setting the run parameters for the Detect volumes function
Abb. 6-35: Run parameter settings at the start of the application
Fig. 6-35: Run parameter settings at the start of the application
 To set the run parameters for the Detect volumes function (see Setting the run parameters for the optical
sensor on p. 28).
Prerequisites
• Application parameters Off
• Run parameter Detect levels
 The filling volume is not measured at the start of the application.
Prerequisites
• Application parameters All positions
• Run parameter Input level manually
 The filling volume must be entered manually when the application is started.
Detect volumes radio button
Activate the Detect volumes function. The
parameters set in the application for the
labware are used.
Use required minimum volume radio button
epBlue assumes that all vessels are filled with the
minimum required volume for this run. Use this
function for dry runs.
Input volumes manually radio button
Deactivate the Detect volumes function. You have
to enter the sample volume manually.
Detect tips checkbox
Activate Detect tips.
Check labware placement checkbox
Activate Check labware placement.