Owner manual

epBlue - Software error messages
epBlue™ with MultiCon
English (EN)
170
0x2122 Parameter conflict:
mixing volume in
source too small for
this tool
The Volume and Pipet. Tool
parameters of a mix procedure
for source vessels do not
match (Volume is less than the
lower limit of the tool's
volume range) (mix procedure
as defined in a command Mix
or as part of a liquid transfer
command via parameter
Options).
 Edit Volume and Pipet. Tool
so that Volume is within
the pipette tool's volume
range.
0x2123 Parameter conflict:
mixing volume in
source greater than
filling volume of
source tube or well
The Volume and Source
parameters of a mix procedure
in the application do not
match (Volume is higher than
the maximum filling volume of
the source vessel) (mix
procedure as defined in a
command Mix or as part of a
liquid transfer command via
parameter Options).
 Edit Volume and Source so
that Volume is within the
allowable filling volume of
the source vessel.
0x2124 Mixing cycles in
destination not
defined
Parameter No. of Cycles in a
mix procedure for destination
vessels was not edited in the
application (mix procedure as
part of a liquid transfer
command via parameter
Options)
 See explanation in
"Cause".
0x2125 Invalid entry for
mixing cycles in
destination
(1 ... 99)
Entry for the parameter No. of
Cycles in a mix procedure for
destination vessels was higher
than the max. limit (1 up to
99 cycles) (mix procedure as
part of a liquid transfer
command via parameter
Options).
 Enter a number between
1 and 99 for the No. of
Cycles parameter.
0x2126 Invalid entry for
mixing speed in
destination
(1 ... 10)
Entry for the parameter Speed
in a mix procedure for
destination vessels was higher
than the max. limit (1 up
to 10) (mix procedure as part
of a liquid transfer command
via parameter Options).
 Enter a number between
1 and 10 for the Speed
parameter.
Code Symptom/message Cause Remedy