Owner manual

epBlue - Software error messages
epBlue™ with MultiCon
English (EN)
169
0x211D Mixing cycles in
source not defined
Parameter No. of Cycles in a
mix procedure was not edited
for the source in the
application (mix procedure as
defined in a command Mix or
as part of a liquid transfer
command via parameter
Options).
 See explanation in
"Cause".
0x211E Invalid entry for
mixing cycles in
source (1 ... 99)
Entry for the No. of Cycles
parameter in a mix procedure
for source vessels was higher
than the max. limit (1 up to 99
cycles) (mix procedure as
defined in a command Mix or
as part of a liquid transfer
command via parameter
Options).
 Enter a number between
1 and 99 for the No. of
Cycles parameter.
0x211F Invalid entry for
mixing speed in
source (1 ... 10)
Entry for the parameter Speed
in a mix procedure for source
vessels was higher than the
max. limit (1 up to 10) (mix
procedure as defined in a
command Mix or as part of a
liquid transfer command via
parameter Options).
 Enter a number between
1 and 10 for the Speed
parameter.
0x2120 Mixing volume in
source not defined
Parameter Volume in a mix
procedure for source vessels
was not edited in the
application (mix procedure as
defined in a command Mix or
as part of a liquid transfer
command via parameter
Options).
 See explanation in
"Cause".
0x2121 Parameter conflict:
mixing volume in
source too large for
this tool
The Volume and Pipet. Tool
parameters of a mix procedure
for source vessels are not in
agreement (Volume is higher
than the upper limit of the
tool's volume range) (mix
procedure as defined in a
command Mix or as part of a
liquid transfer command via
parameter Options).
 Edit Volume and Pipet. Tool
so that Volume is within
pipette tool's volume
range.
Code Symptom/message Cause Remedy